

INSTALLATION GUIDE
0.2um EPS High Flux
Capsule Filter
RephlLe Catalogue Number:
RAFFC0250
RAFFC0200
Corresponding Millipore Part Number:
MPGP04001
MPGP02001
SIMFILTER
This product is compatible to the Millipore corresponding final filter . Please refer to Millipore’s User Manual for a detailed instruction on installation.
A brief description of the installation process is described below.
1 Set the system to STANDBY mode
2 Remove the used final filter
3 Screw the new final filter onto the system till finger tight.Do not use any Teflon tape, as this would damage the female.
4 Put the system into PRE-OPERATE mode by pressing the OPERATE/STANDBY tbtton for two seconds.
5 Dispense water,and then slowly open the vent cap on the filter to purge air from the final filter to purge air from the final filter.Allow water to run out of the vent to ensure all air is purged from the final filter.
6 Tighten the vent cap. Stop dispensing water.

安装指南
0.2um PES终端过滤器
RephiLe货号 | 对应Millipore货号 |
RAFFC0200 | MPGP02001 |
RAFFC0250 | MPGP04001 |
本产品可完全代替相对应的密理博终端过滤器。安装本产品是可同时参阅Millipore的用户手册的详细安装说明。
安装过程简单描述如下:
- 1. 将系统置于“待机”模式。
- 2. 旋下用过的终端过滤器。
- 3. 将新的终端过滤器旋紧在系统上。不要使用生胶带,因为这样会损坏内螺纹。
- 4. 将系统置于“就绪”模式。
- 5. 取水,缓慢旋开终端微滤器上的排气旋钮,将空气从终端过滤器内排出。使纯水充满终端过滤器。
- 6. 旋紧排气旋钮,停止取水。
